InSinkErator 11327H Manuál s instrukcemi stáhnout pdf

Installation Instructions

1. Insert six screws (1) through the sink

bowl connection lip (or loose ring), flat

gasket (2) and mounting flange (3). With

screws protruding through the mounting

flange (3) attach six washers (4) and six

nuts (5). Tighten all screws evenly.

2. Position the disposer for plumbing

hookup and check the location of the

keyhole slots in the disposer body flange.

3. Attach two screws (7) through opposite

holes in the mounting gasket (6) and

into the threaded fasteners in the

mounting flange (3). The screws (7)

should be protruding approximately

1/4 inch below the mounting gasket (6).

4. Position the disposer beneath the

mounting gasket (6) and engage the two

protruding screws in the keyhole slots

in the disposer body flange. Assemble

the remaining four screws (7). Tighten

all screws evenly to secure the unit.

Mounting Adaptor (#11327-H)

Part No. 13966-H October 2007

This adaptor will fit a sink opening of:

4-1/2" I.D. and 6-7/8" O.D.

5-7/8" I.D. and 6-1/2" O.D.

5-7/8" I.D. and 6-7/8" O.D.

with 5-1/2" bolt hole circle

Sink Bowl

Connection Lip

Threaded Fasteners

(3) Mounting Flange

(#11189-A)

(4) Washer

(#11180)

(5) Nut

(#11179)

(2) Flat Gasket

(#11292-C)

(1) Screw

(#11294)

(7) Screw

(#1491)

(6) Mounting Gasket

(#11016)

Disposer

Body Flange

Keyholes

Sink

Mounting Adaptor (#11327-H) 1

Shrnutí obsahu

Strany 1 - Mounting Adaptor (#11327-H)

Installation Instructions1. Insert six screws (1) through the sink bowl connection lip (or loose ring), flat gasket (2) and mounting flange (3).

Komentáře k této Příručce

Žádné komentáře

InSinkErator 11327H Manuál s instrukcemi

Procházejte online nebo si stáhněte Manuál s instrukcemi pro ne InSinkErator 11327H. InSinkErator 11327H Instructions / Assembly Uživatelská příručka

Shrnutí obsahu

Komentáře k této Příručce

Související produkty a manuály pro ne InSinkErator 11327H